english | russian | فارسی
Construction Chemicals Co.  
Construction Chemicals Co.
» View Product
 
Epoxy Grout GE-3
Description: GE-3 Is a three component grout based on Epoxy Resin. GE-3 Is generally same as GE-1, GE-2.
GE-3 enables the user to fill high thickness (up to 30 cm) grouting in one stage without any decreasing of its mechanical strength.
Uses: - Steel mill equipment such as rolling mills
manipulating tables ,run out tables, coilers
an hoists.
- Industrial equipment such as Compressors,
Pumps, Pulverizes and presses.


Advantages: - Impact resistant and resilient.
- Non shrink and fast hardening.
- Chemical resistant
-High yield formulation so that can be used up to 40° C .


Surface preparation : The surface must be clean, dry and free from any contamination like oil and grease
Mixing Ratio : Resin: 100 parts by weight.
Hardener: 55 parts by weight
Filler: 300 parts by weight.
Application: Suitable amount of resin and hardener should be mixed in a mortar mixer operating with 20 RPM or less according to the mixing ratio for 1 or 2 minutes and then added the desired amount of filler. Continue mixing until all filler is coated, then put it immediately into the place and level it.
Hint: Take care to eliminate all air pockets.
The minimum depth of grout placement should be ½ inch and maximum depth of pour should be 3 inch.
For exceptionally deep spots, fill in 3 lifts allowing each lift to cure before placing additional grout.
Technical Data:
Type: 3 component
Sp.Gr: Admixtire 2 kg/Lit
Pot life: 30-60 min depends on temp.
Shelf life : 12 months
Compressive Strange : min 850 kg/cm²
Tensile strength : min 500 kg/cm²
Hardness: 95 kg/cm²
Packaging: Resin: 18 kg, Hardener: 10 kg and Filler: 20 kg plastic bag
Images
Certificates
All right reserved